Description
The Profibus Terminator is exactly that. It will terminate the bus with a resistor and prevent from any signal reflections.
Profibus Terminator
The T1 Terminator provides active termination for PROFIBUS segments which are based on RS 485. This component enables you to switch off or remove the last devices on a segment without disturbing the bus communication. This way you reduce the risk of faults and thus potential downtime. The redundant power supply of the T1 increases reliability even more. The on-board DB9 connector can be used as hookup point for diagnostic tools.
Product Details
- Bus termination independent of terminal device due autonomous power supply
- 9.6 kbps to 12 Mbps
- Removable screw terminals and 1 DB9 connector
- Operating Voltage: 19..28 VDC
- Current consumption: < 60 mA
- Redundancy: Power 1 OR 2
- Diagnostic LEDs to indicate the status of the power supply
- 390 / 220 / 390 Ohm
- Supports all PROFIBUS RS 485 protocols
Reviews
There are no reviews yet.